Bleed overlap in facing pages

[Jonas Fried]

I am using the option of facing pages and have my bleed set to 3mm. However
in the middle where the pages join the 3mm bleed shared between the 2 pages.
Actually "shared is not the right word as the right page seems to take
priority and bleeds (so to speak) over the left. Result is of course the
left page does not have any bleed. Is this gonna be OK for the printers (CAN
it be OK??) and if not, how do I obtain 2x 3mm bleed in the centre?
Thank you for any advice
Jonas

[Hebnix]

I have found that most commercial printers require a 1/8" bleed, and prefer
inches as to points and millimeters (in US) and as far as the center of the
2 page spread, you could set it up as 1 picture box covering both pages from
far left to far right, then either page would have continuous bleed and it
will align perfectly, because it's the same box.

"Jonas Fried" <junkhunk@arcor.de> wrote in message
news:cdgvmb$svh$01$1@news.t-online.com...

> I am using the option of facing pages and have my bleed set to 3mm.

However

> in the middle where the pages join the 3mm bleed shared between the 2

pages.

> Actually "shared is not the right word as the right page seems to take
> priority and bleeds (so to speak) over the left. Result is of course the
> left page does not have any bleed. Is this gonna be OK for the printers

(CAN

> it be OK??) and if not, how do I obtain 2x 3mm bleed in the centre?
> Thank you for any advice
> Jonas
>
>