Hi!
Got a DesignJet 3500CP in the office (large format, roll fed inkjet, PS3). ID2 printed to it beautifully - in fact, it was the only piece of software that did a really good job. Pagemaker hated it.

Installed the trial of IDCS, and I can't seem to print to designjet. It says that the paper is too small, and just spits out foot after foot of blank paper. I'm using the same settings I always did.

Exported to PDF, the same file prints just fine from Acrobat. Any thoughts on why the sudden change? Nothing else on the PC is different...the PPD is the same, the OS..all I did was install InDesign CS.

Steve