exporting .png to .html problem

[Linda Rathgeber]

On 8/15/2003 9:46 AM, "no--nickname" [email]webforumsuser@macromedia.com[/email] wrote:

> I am creating a navigation bar from a .gif image in fireworks. I
> select just the image and copy to new page, save as a .png file, set
> my hyperlinks and then choose to export to .html. While inspecting my
> nav bar .html source code I get a "1 pixel row added to the top" and
> "1 pixel column added to the far right side". I am looking for cause
> of this and way to correct it, source code is below.

They are shim rows. To eliminate them, choose File > HTML Setup and
click on the Table tab. Choose the Single Table, No Spacers option. As
long as you have used proper slicing technique your table won't explode
and your table markup will be nice and lean. "Woe and woe again to him
who spans rows and columns with his slices. For he shall be cast into
table hell."


Best regards,
Linda Rathgeber
----------------
Victoriana | [url]http://www.projectseven.com/dpacks/vic/index.htm[/url]
Theme Pack 03 - Club | [url]www.projectseven.com[/url] |mm2| themes
Contributor *PVII Foundations* [url]www.projectseven.com[/url]
Co-author *Playing with Fire* [url]www.playingwithfire.com[/url]
Team MM Fireworks Volunteer | [url]www.macromedia.com/go/team[/url]
-----------------

[no--nickname webforumsuser@macromedia.com]

I did what you said and apparently I have slicing issue you warned about, can you provide some insight. I have two slices on this image, one for a email hyperlink and the other for another page reference.

[Linda Rathgeber]

On 8/15/2003 11:36 AM, "no--nickname" [email]webforumsuser@macromedia.com[/email] wrote:

> I did what you said and apparently I have slicing issue you warned
> about, can you provide some insight. I have two slices on this
> image, one for a email hyperlink and the other for another page
> reference.

Make sure your slices are set up in neat rows and columns, like a
checkerboard, If they are staggered, like a brick wall, the table will
not hold together without the shims. That said, I think there's an
extension or command available that will move the shim rows from the top
and left sides to the right side and bottom. Unfortunately, I don't
remember who created it and where you can find it.

You could try the nested table option.


Best regards,
Linda Rathgeber
----------------
Victoriana | [url]http://www.projectseven.com/dpacks/vic/index.htm[/url]
Theme Pack 03 - Club | [url]www.projectseven.com[/url] |mm2| themes
Contributor *PVII Foundations* [url]www.projectseven.com[/url]
Co-author *Playing with Fire* [url]www.playingwithfire.com[/url]
Team MM Fireworks Volunteer | [url]www.macromedia.com/go/team[/url]
-----------------