Installation trouble

[Rob Farmer]

I have tried to install Red Hat Linux 9 on my system, but I recieve a
message the my system isn't supported by this version when the installer
tries to format the /boot partition. I am installing on my second hard drive
for a dual-boot with Windows 98. I meet all the system requirements and have
tried to install in text mode, but it doesn't work. Please help.

System Configuration:
ASUS P5A-B
AMD K6-2 500
288 MB PC-100 RAM
MSI MS-8807 TNT2 16 mb ram
WD 60GB & Fujitsu 4GB Hard drives
Compaq 48x Cd-rom

[essecosky]

I am trying to install CF MX 6.1 on an dedicated Windows 2003 server without
IIS installed. There is another seperate Windows 2003 IIS 6 server that will
be the web server for CF MX 6.1. When I try to run the web server
configuration wizard on the CF MX server, I am unable to attach and configure
the web server on the other IIS 6 server. Which leaves me with a few questions:

Does anyone know what components need to be installed on each server to allow
for this setup to work? I read a doc to install jrun4 on the web server, but
cannot find the executable for it on the cd's or web site.

There is a firewall between the two servers, what ports need to be opened for
proper operation?

Unfortunately, the doc's that are on CF's web site are not very clear and seem
to assume a lot.

Any help would be greatly appreciated.

Thanks,
Emery

[xentrix]

Check out the following doc for configuring Distributed Mode.

[url]http://www.macromedia.com/support/coldfusion/administration/cfmx_in_distributed_mode/[/url]

Andy