Ask a Question related to Linux Setup, Configuration & Administration, Design and Development.
-
Nick Upson #1
RH9 boot failure
I'm trying to install RH9 on an PC made of old bits based on a P133
and it seems to go fine, install the default server packages goes
through. Then I reboot so that it runs on what has just been
installed -it hangs.
Specifically it hangs immediately after displaying info about the
3 hard drives. I've tried using grub and lilo - both produced the
same behaviour. I don't know what it's trying to do so I've no idea
on where to start.
Nick Upson Guest
-
Stage 1 Boot failure
I get Stage 1 boot failure when I have installed Open Server 5.0.7 on a HP EVO N610c with an IBM Travelstar hard-disk, model 1C25N030ATCS05 I... -
DISK BOOT FAILURE
i am unable to boot from /dev/hda. i have a boot disk and that worked. i am trying to figure out why i cannot boot from the hard drive. i have... -
looping boot failure
While trying to read a flashpath diskette, XP seemed to hang and ultimately had to reboot. Now I have a looping boot failure. XP starts to load,... -
Boot Disk Failure
I have an HP 753c computer with 1 gb of memory. My system is slow and hangs up while downloading. Also, I have come back to the computer 3 times... -
failure to boot existing system neither from disk nor from cdrom -s
Dear folks My beutifull Sunblade 150, after about a year of work issued msg (at boot): can't read disk label can't open disk label package ...
Reply With QuoteSimilar Questions and Discussions
Posting Permissions
- You may not post new threads
- You may post replies
- You may not post attachments
- You may not edit your posts
